The Collection

Pad Production

Layout

Cutting layout & output calculator

PadØ 125 Oversize25 mm BlankØ 150 Pitch155 mm

Each pad is milled from an oversized round blank. Block dimensions are editable in the table — raw material sizes vary per delivery.

Cutting layout

to scale · 1 layer
0blanks / layer
0layers (block ÷ pad thickness)
0pads from this block
0%material utilization / layer

Parameters

Pad size125 mm
mm
Blank Øderived
Ø 150 mm
mm
mm
90%

Share of blanks that become sellable pads — covers scrap, setup runs and milling defects.

Pitch between centres: 155 mm (blank Ø + clearance). All values in millimetres.

Total pads · theoretical
0
staggered layout · all 4 blocks
Realistic output
0
at 90% usable
Blanks per layer
0
sum across 4 blocks
Gain vs straight rows
▲0%
+0 pads / layer

Output by material

theoretical vs realistic
Theoretical Realistic (usable share applied)

Output share

of realistic total

Output detail by block

dimensions editable · click headers to sort
Material Spec Length · mm Width · mm Thickness · mm Blanks/layer Layers Theoretical pads Realistic pads
Total

Layer planner

one whole layer per size — the blank cutter can't mix sizes

Saved runs0

No saved runs yet — set your parameters and press “Save run”.

Recommended production sequence

softest / cheapest first